Boot up the Tech2 and then turn vehicle ignition to on (Engine NOT running) ģ).Go to Tech2 Main Menu, select Service Programming and enter vehicle information as requested Ĥ).Press the request info soft key on the Tech 2 ĥ).Identify whether an existing module or a new module is being programmed.įor an existing module, the Tech 2 obtains calibration information from the controller.įor a new module, the Tech 2 instructs you to remove the old module and install the new module in the vehicle. Connect Tech2 to vehicle DLC (Note: make sure Tech2 and vehicle both OFF) Ģ). Perform remote SPS Using TIS 2000 as follows:ġ). Ensure that cable connection is secure (A disconnected cable could cause controller failure). Ensure that the vehicle battery is fully charged, and make sure a battery charger IS NOT connected to the vehicle ģ.
Ensure that the GM Tech2 and the terminal are both equipped with the latest software Ģ. Important Notes (Prior to performing SPS):ġ. All programming steps are activated and finalized through PC. The GM SPS, abbreviated by Service Programming System, is a personal computer (PC) application used to reprogram vehicle electronic control modules (ECMs).
Note: You are also available to GM TIS2000 CD with USB key for GM vehicle on OBD2EXPRESS, while if you order GM Tech2 scanner with SAAB software, you’d better choose SAAB TIS2000 CD with USB key. Package comes with TIS 2000 software CD, which can be used to perform remote SPS. NEW Tech2 Diagnostic Scanner is a good diagnostic tester used to diagnose GM Vehicles - GM, SAAB, OPEL, SUZUKI, ISUZU and HOLDEN.